Moulded In Application Instructions

process

STEP ONE

Using a solvent and cloth clean the mould surface to remove any graphic residue or impurities on the mould surface.
application1

STEP TWO

Spray the mould surface with an even coating of Moulded In adhesive, allow adhesive to tack off.
application4

STEP THREE

Position graphic in place, using your application pad, rub the back of the clear polyester to transfer the graphic onto the mould surface.
application5

STEP FOUR

Carefully remove and discard the clear polyester.
products

STEP FIVE

After removing Polyester backing, it is recommended on larger volume moulds that you spray the back of the graphic with Adhesive or surface enhancer to protect the graphic during the cooking process.